To Next Page

To Previous Page

Temposonics

R-Series V PROFINET IO RT & IRT

Operation Manual

I 28 I

The status of the switching points is reported in parallel to the position

values or velocity values via the PROFINET protocol. A magnet must

be speciﬁed for each switching point, which is used to check the

respective limit. For a single position measurement with one magnet,

the same magnet is assigned to the high and the low limit. For a

multi-position measurement, you can assign different magnets on

the sensor to the high and the low limit. Fig. 46 shows an example

with three magnets. Magnet 1 is used to check the low limit, while the

magnet 3 is used to monitor the high limit. Magnet 2 has no inﬂuence

on the checking of the work area.

Fig. 46: Example of checking the switching points at R-Series V PROFINET with 3 magnets

Bit value

Stroke length

Low limit High limit

Magnet 1 Magnet 2 Magnet 3

• Ignoring offsets conﬁgured in the project: You can use the "Conﬁg

Flags 1" entry to set whether the sensor should accept or ignore

the offsets transmitted by the controller when establishing the

connection. You can adjust this in the module parameters of the

sensor in the "Conﬁg Flags" section (Fig. 47). You can set the

following values for bit 1 of the "Conﬁg Flags 1" entry:

• Value 0: The offsets conﬁgured in the project are accepted by

the sensor

• Value 1: The offsets conﬁgured in the project are ignored by the

sensor

The other bits of "Conﬁg Flags 1" as well as the entries "Conﬁg Flags 2"

and "Conﬁg Flags 3" have no inﬂuence on the MTS proﬁle.

Fig. 47: Conﬁg Flags – MTS proﬁle

MTS Sensors Temposonics R Series User Manual

Other manuals for MTS Sensors Temposonics R Series