MTS Sensors Temposonics R Series User Manual

10.2 Technical data Temposonics

R-Series VRH5
tpt
Interface PROFINET RT
PROFINET IRT version 2.3
Data protocol 0763URğOHDQG(QFRGHU3URğOH9
Data transmission rate 100 MBit/s (maximum)
Measured value Position, velocity/option: Simultaneous multi-position and multi-velocity measurements up to 30 magnets
asrnt paratrs
Resolution: Position 0.5…100 μm (selectable)
Cycle time
Stroke length ≤ 50 mm ≤ 715 mm ≤ 2000 mm ≤ 4675 mm ≤ 7620 mm
Cycle time 250 µs 500 µs 1000 µs 2000 µs 4000 µs
Linearity deviation

Stroke length ≤ 500 mm > 500 mm
Linearity deviation ≤ ±50 µm < 0.01 % F.S.
Optional internal linearization/LQHDULW\WROHUDQFHDSSOLHVIRUWKHğUVWPDJQHWIRUPXOWLSRVLWLRQPHDVXUHPHQW
Stroke length 25…300 mm 300…600 mm 600…1200 mm
typical ± 15 µm ± 20 µm ± 25 µm
maximum ± 25 µm ± 30 µm ± 50 µm
Repeatability < ±0.001 % F.S. (minimum ±2.5 m) typical
Hysteresis < 4 μm typical
Temperature coefficient < 15 ppm/K typical
pratin onditions
Operating temperature ũĽŹ&ũĽŹ)
Humidity 90 % relative humidity, no condensation
Ingress protection IP67 FRQQHFWRUVFRUUHFWO\ğWWHG
Shock test 150 g/11 ms, IEC standard 60068-2-27
Vibration test
30 g/10…2000 Hz, IEC 60068-2-6 (excluding resonant frequencies) /
RH5-J: 15 g/10…2000 Hz, IEC standard 60068-2-6 (excluding resonant frequencies)
EMC test Electromagnetic emission according to EN 61000-6-3
Electromagnetic immunity according to EN 61000-6-2
The sensor meets the requirements of the EC directives and is marked with
Operating pressure 350 bar (5,076 psi)/700 bar (10,153 psi) peak (at 10 × 1 min) for sensor rod/RH5-J: 800 bar (11,603 psi)
Magnet movement velocity Any
sinatria
Sensor electronics housing Aluminum (painted), zinc die cast
Sensor flange Stainless steel 1.4305 (AISI 303)
Sensor rod Stainless steel 1.4306 (AISI 304L)/RH5-J: Stainless steel 1.4301 (AISI 304)
Stroke length 25…7620 mm (1…300 in.)/RH5-J: 25…5900 mm (1…232 in.)
ania ontin
Mounting position Any
Mounting instruction
Please consult the technical drawings on page 10
Etria onntion
Connection type
2 × M12 female connectors (D-coded), 1 × M12 male connector (A-coded)
2 × M12 female connectors (D-coded), 1 × M8 male connector
Operating voltage +12…30 VDC ±20 % (9.6…36 VDC)
Power consumption Less than 4 W typical
Dielectric strength 500 VDC (DC ground to machine ground)
Polarity protection 8SWRũ9'&
Overvoltage protection Up to 36 VDC
5/ With position magnet # 251 416-2
Temposonics
®
R-Series V PROFINET IO RT & IRT
Operation Manual
I 38 I

MTS Sensors Temposonics R Series Specifications

General

Brand	MTS Sensors
Model	Temposonics R Series
Category	Accessories
Language	English