32
9. Servo settings
Dual rate and expo may be used on the transmitter as normal. Ser-
vo center or neutral rudder position must be set mechanically on the
model.
!
The servo output for the throttle must not be reassigned. This would
pose a danger of undesired engine start-up during programming.
!
It must be ensured that all servo settings are made on the WINGSTABI and not
the transmitter. The trim on the transmitter must remain neutral or zero. Mixers
must be deactivated at all times at the transmitter.
Advanced servo mapping
For models which use more servos than those shown on page 21 of these in-
structions in the standard wiring diagrams, map them in the servo window. Each
servo output is freely assignable in its function. It is however recommended that
servos which have already been assigned be left alone.
To Next Page
Loading...
Need help?
General
