37
15. Optimisation
Once you have successfully acquired the basic settings of the assistant or the
mode template through ight, you can – if required – then perform optimizations
in “Advanced settings”. To help you with this, the WINGSTABI clearly displays all
default settings in all ight phases. Start by right clicking the page header for
each phase in order to select the standard settings for purely damping mode, for
an optimised damping mode, for fully stabilised mode or even aerobatics mode.
By looking at the differences in the settings, you can gain a greater insight into
the various modes and carefully work in some changes of your own. The modi-
cations should be as minimal in severity and as few in number as possible, so
that they can be recognized during test ights. Step by step optimisation leads
to success more quickly than too many changes at the same time that are too
extreme. Re-save the settings le with a new name after every change, in order
to always have the possibility of returning to the previous settings.
To Next Page
Loading...
Need help?
General
