National Instruments NI CompactDAQ 9184 User Manual

1-4 | ni.com
Chapter 1 Getting Started with the cDAQ Chassis
Special Guidelines for Marine Applications
Some products are Lloyd’s Register (LR) Type Approved for marine (shipboard) applications.
To verify Lloyd’s Register certification for a product, visit
ni.com/certification and
search for the LR certificate, or look for the Lloyd’s Register mark on the product label.
Caution In order to meet the EMC requirements for marine applications, install the
product in a shielded enclosure with shielded and/or filtered power and input/output
ports. In addition, take precautions when designing, selecting, and installing
measurement probes and cables to ensure that the desired EMC performance is
attained.
Hardware Symbol Definitions
The following symbols are marked on your cDAQ chassis.
Caution When this symbol is marked on a product, refer to the Safety Guidelines
section for information about precautions to take.
ESD When this symbol is marked on a product, the product could be damaged if
subjected to Electrostatic Discharge (ESD) on the connector pins of any I/O port.
To prevent damage, industry-standard ESD prevention measures must be employed
during installation, maintenance, and operation.
EU Customers At the end of the product life cycle, all products must be sent to
a WEEE recycling center. For more information about WEEE recycling centers,
National Instruments WEEE initiatives, and compliance with WEEE Directive
2002/96/EC on Waste and Electronic Equipment, visit
ni.com/environment/
weee
.
⬉ᄤֵᙃѻક∵ᶧ᥻ࠊㅵ⧚ࡲ⊩ ˄Ё೑ ˅
Ё೑ᅶ᠋
National Instruments
ヺড়Ё೑⬉ᄤֵᙃѻકЁ䰤ࠊՓ⫼ᶤѯ᳝ᆇ⠽䋼ᣛҸ
(RoHS)
DŽ݇Ѣ
National Instruments
Ё೑
RoHS
ড়㾘ᗻֵᙃˈ䇋ⱏᔩ
ni.com/
environment/rohs_china
DŽ
(For information about China RoHS compliance,
go to
ni.com/environment/rohs_china
.)

National Instruments NI CompactDAQ 9184 Specifications

General

Brand	National Instruments
Model	NI CompactDAQ 9184
Category	Chassis
Language	English