Native Instruments KOMPLETE KONTROL S49 User Manual

4.1 Connecting the Keyboard to the Computer
To connect the KOMPLETE KONTROL S-Series keyboard to your computer:
1. Attach the ‘device end’ of the included USB cable to the USB socket on the rear panel of
the keyboard.
2. Attach the ‘computer end’ of the USB cable to an available USB 2.0 (or later) port on
your computer.
3. Press the power switch on the rear panel of the keyboard to switch it on.
→ The keyboard is now detected by the operating system.
Non-powered USB hubs are not supported. The keyboard should always be connected
directly to the USB port of the computer, or be used with a powered USB hub.
Setting up KOMPLETE KONTROL
Connecting the Keyboard to the Computer
KOMPLETE KONTROL - Manual - 19

Native Instruments KOMPLETE KONTROL S49 Specifications

General

Brand	Native Instruments
Model	KOMPLETE KONTROL S49
Category	Electronic Keyboard
Language	English