The GATE RESET function, mapped to Button 4 of the Control section lets you reset the GATE
parameter to its default value of 100% at any time.
To display the set value of the GATE parameter, tap Knob 8.
14.8 Setting the Advanced Parameters
The ADVANCED parameters Retrigger, Repeat, Offset, and Inversion allow you to explore alter-
native versions of the same arpeggiator sequence.
The ADVANCED parameters Retrigger, Repeat, Offset, and Inversion.
14.8.1 Advanced Retrigger
The first ADVANCED parameter, Retrigger, is only available in Arp mode. On the keyboard, it is
mapped to Knob 1 of the Control section when PAGE 2 of ARP EDIT mode is selected. Retrig-
ger sets a number of steps in the arpeggiator sequence after which the sequence restarts its
cycle, regardless of the number of pitches in the sequence.
For example:
▪ If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Retrigger is set
to 3, the Arpeggiator output is 1 - 2 - 3 - repeat.
▪ If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Retrigger is set
to 8, the Arpeggiator output is 1 - 2 - 3 - 4 - 5 - 1 - 2 - 3 - repeat.
Rests in a Sequence are treated as steps:
Playing and Editing the Arpeggiator
Setting the Advanced Parameters
KOMPLETE KONTROL - Manual - 202
To Next Page
Loading...
Need help?
General
