▪ 3
▪ 4
▪ 5
▪ 6
▪ 7
▪ 8
To display the set value of the OCTAVES parameter, tap Knob 6.
14.7.2 Other Dynamic
The second OTHER parameter, Dynamic, is only available in Arp mode. On the keyboard it is
mapped to Knob 7 of the Control section when Arpeggiator Edit mode is selected. It reads the
velocity of the input—e.g. a key you pressed on the KOMPLETE KONTROL S-Series keyboard
or an incoming MIDI note from the host—and scales it by the factor you set with the Dynamic
parameter. The scaling is applied per note. The velocity of each played note is taken and mul-
tiplied by the value set with the Dynamic parameter.
Dynamic is a drag control that lets you set a value between 1.0% and 200.0%.
To display the set value of the DYNAMIC parameter, tap Knob 7.
14.7.3 Other Gate
The third OTHER Parameter, Gate, is available in both Arp and Note Repeat mode. On the key-
board, it is mapped to Knob 8 of the Control section when Arpeggiator Edit mode is selected.
It lets you decide the length of the notes in your sequence. Setting a value between 1% and
99% makes the duration of the notes shorter than they otherwise would be. Setting a value
between 101% and 200% instead elongates the duration of the notes by the selected value.
Gate is a drag control that lets you set a value between 1.0% and 200.0%.
Playing and Editing the Arpeggiator
Setting the Other Parameters
KOMPLETE KONTROL - Manual - 201
To Next Page
Loading...
Need help?
General
