▪ If the arpeggiator sequence consists of 6 pitches, the Sequence is 1 - 2 - 3 - rest - 4 - 5 -
6 – rest, and Retrigger is set to 5, the Arpeggiator output is 1 - 2 - 3 - rest - 4 -repeat.
14.8.2 Advanced Repeat
The second ADVANCED parameter, Repeat, is only available in Arp mode. On the keyboard, it
is mapped to Knob 2 of the Control section when PAGE 2 of ARP EDIT mode is selected. Re-
peat sets a number by which each step in the arpeggiator sequence is repeated.
For example:
▪ If the arpeggiator sequence consists of a 3 note cycle (1 - 2 - 3) and Repeat is set to 3, the
Arpeggiator output is 1 - 1 - 1 - 2 - 2 - 2 - 3 - 3 - 3 - repeat.
14.8.3 Advanced Offset
The third ADVANCED parameter, Offset, is only available in Arp mode. On the keyboard, it is
mapped to Knob 3 of the Control section when PAGE 2 of ARP EDIT mode is selected. Offset
sets a number by which the steps in the arpeggiator sequence are shifted in the cycle.
For example:
▪ If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Offset is set to
0, the Arpeggiator output is 1 - 2 - 3 - 4 - 5 - repeat.
▪ If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Offset is set to
+1, the Arpeggiator output is 2 - 3 - 4 - 5 - 1 - repeat.
▪ If the arpeggiator sequence consists of a 5 note cycle (1 - 2 - 3 - 4 - 5) and Offset is set to
-1, the Arpeggiator output is 5 - 1 - 2 - 3 - 4 - repeat.
14.8.4 Advanced Inversion
The fourth ADVANCED parameter, Inversion, is only available in Arp mode. On the keyboard, it
is mapped to Knob 4 of the Control section when PAGE 2 of ARP EDIT mode is selected. In-
version adds inverted alternations of the arpeggiator sequence to the cycle.
For example:
▪ If the arpeggiator sequence consists of a 3 note cycle (1 - 2 - 3), Type is set to Up, and
Inversion is set to 0, the Arpeggiator output is 1 - 2 - 3 - repeat.
Playing and Editing the Arpeggiator
Setting the Advanced Parameters
KOMPLETE KONTROL - Manual - 203
To Next Page
Loading...
Need help?
General
