137
To Bridge Into A Dial Intercom Call
STEP 1: Press the DICM key, lift handset or press
key.
STEP 2: A three-party conference is established.
CONFERENCE
STEP 1: With a call in progress, press key and
dial desired number.
STEP 2: After call is answered, press the Conf. soft
key. Three-way conference is established.
STEP 3: If one party hang up, other two remain con-
nected. The Conf key’s LED goes out.
TO SWITCH A CALL WITH TRANS-
FER KEY
STEP 1: While engaged in a call and wishing to con-
sult a third party, press key. The orig-
inal caller is automatically placed on hold.
STEP 2: Dial desired party to consult.
STEP 3: Press key to return to original caller.
Third party is automatically placed on hold.
STEP 4: By repeating these steps, it is possible to al-
ternate between calls. The display indicates
connected station or trunk any given time.
Note:
Bridging is an optional feature.
Note:
Dial intercom provides a Dial Intercom group
where each member of the group may be called
by a 1-digit or 2-digit number without using their
prime lines.
OVERRIDE 3
1:25 PM MON 11 MAY 2015
CONF
1:25 PM MON 11 MAY 2015
Note:
The Conf key is accommodated on only DTZ-2E-
3 and DTZ-6DE-3. If using the terminals without
key, use a soft key or programmable
feature key to which conference feature has been
assigned.
CONF
Mic >>>
1:25 PM MON 11 MAY 2015
To Next Page
Loading...
Need help?
General