EasyManuals Logo
Home>NEC>Switch>QX-S5526P

NEC QX-S5526P User Manual

NEC QX-S5526P
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
Installation Guide
QX-S5500 Series Ethernet Switches
6
Upgrading Software
Writing to flash................................................done
8) Enter "0" in the download program menu to restart the device. After that, the updated
Boot ROM file becomes effective.
NOTE:
When making switch restart from the Boot menu, please choose "0" by the Boot menu.
6.2.3 Upgrade of software by FTP
1) Choose Ethernet interface of QX-S5500 series switch for download. Connect
QX-S5500 series switch to the terminal where a downloaded file through an interface
is put. (We assume that the IP address of a terminal is known.) At the same time,
Connect QX-S5500 series switch to the terminal where a downloaded file through a
console port is put.
2) Execute a FTP server program on the terminal connected to QX-S5500 series switch
through Ethernet interface for download. Specify a file pass of an upgrade program.
3) Run the terminal emulation program on the PC connected with the switch’s console
port.
4) Select "1" in the Boot Menu, and then press Enter to enter the download program
menu shown below:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):2
5) Select "2" in the download program menu to download the software by using FTP.
Please push down <Enter>. The following message begins setting of a FTP parameter,
and is indicated.
Please modify your FTP protocol parameter:
Load File name:
Switch IP address:
Server IP address:
FTP User Name:
FTP User Password:
6) Input related information based on an actual important matter, and push down <Enter>.
The following message is indicated.
Are you sure to download file to flash?Yes or No(Y/N)
7) Enter "Y" to start file downloading or "N" to return to the Boot ROM update menu. If
you enter "Y", the system begins to download and update the software. Upon
completion, the system displays the following information to show the loading process
is completed:
Loading ........................................................done
Writing to flash................................................done
6-4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC QX-S5526P and is the answer not in the manual?

NEC QX-S5526P Specifications

General IconGeneral
BrandNEC
ModelQX-S5526P
CategorySwitch
LanguageEnglish

Related product manuals