22
Emptying the evaporator dish and refilling the water tank
An audible signal sounds after approx. 30 minutes. "Empty
evaporator dish and refill water tank" appears in the text
display.
1. Open the appliance door.
2. Remove the descaling solution from the evaporator dish
using the cleaning sponge provided.
3. Rinse the water tank thoroughly, fill with water and reinsert.
"Appliance ready to rinse" and "1st rinse" appear in the text
display.
4. Close the appliance door.
1st rinse
Press the Start button.
The appliance starts rinsing. "1st rinse" appears in the display.
Empty evaporator dish
After 20 seconds, "Empty evaporator dish" appears in the text
display.
1. Open the appliance door.
2. Thoroughly rinse out the cleaning sponge.
3. Remove the remaining water from the evaporator dish using
the cleaning sponge.
4. Close the appliance door.
2nd rinse
Press the Start button.
The appliance starts rinsing. "2nd rinse" appears in the display.
Removing the remaining water
After 20 seconds, "End" and "Empty evaporator dish" appear in
the text display.
1. Open the appliance door.
2. Remove the remaining water from the evaporator dish using
the cleaning sponge.
3. Wipe out the cooking compartment using the cleaning
sponge and then dry with a soft cloth.
4. Turn the operating mode selector back to the Û position.
5. To turn off the appliance, press in the operating mode
selector so that it clicks into place.
Descaling is complete.
Cancelling the descaling
Note: After cancelling the descaling, you must rinse the
appliance twice. The appliance is locked against other
applications until the second rinsing operation is complete.
1. Press and hold the Stop button to cancel the descaling
process.
To ensure that no descaling solution remains in the
appliance, it must be rinsed twice after a cancellation.
2. Press the Start button.
"Empty evaporator dish and refill water tank" appears in the
text display.
Now proceed as described in the "Emptying the evaporator
dish and refilling the water tank" section.
Descaling the evaporator dish only
You can also use "Descale" if you do not wish to descale the
whole appliance, but only the evaporator dish in the cooking
compartment.
The only difference is as follows:
1. Prepare a descaling solution by mixing 100 ml water and
20 ml liquid descaler.
2. Completely fill the evaporator dish with descaling solution.
3. Fill the water tank with water only.
4. Start "Descale" as described.
You can also descale the evaporator dish manually.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
: Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
: Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the aftersales service.
Removing the appliance door
1. Open the appliance door fully.
2. Fold out the locking levers on the left and right fully (figure A).
The hinges are secured and cannot snap closed.
3. Close the appliance door until you feel some resistance.
4. With both hands, grip the door on the left and right-hand side,
close the door a little more and pull it out (Fig. B).
Fitting the appliance door
Refit the appliance door after cleaning.
1. Insert the hinges in the left and right-hand bracket (figure C).
The notch on both hinges must engage.
2. Open the appliance door fully.
3. Close the locking levers on the left and right-hand side fully
(figure D).
The appliance door is secured and can no longer be
removed.
4. Close the appliance door.
Cleaning the door panels
To facilitate cleaning, you can remove the door panels from the
appliance door.
: Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
To Next Page
Loading...
Need help?
General
