9
Operating the appliance
In this section, you can read about
■ how to fill the water tank
■ how to switch the appliance on and off
■ what to note after each cooking operation
Filling the water tank
When you open the appliance door, you will see the water tank
on the right-hand side.
Caution!
Use of unsuitable liquids may damage the appliance
■ Only use fresh tap water, softened water or uncarbonated
mineral water.
■ If your tap water is very hard, we recommend that you use
softened water.
■ Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
You can obtain information about your tap water from your
water supplier. The water hardness can be checked with the
test strips enclosed.
Fill the water tank before each use:
1. Open the appliance door and take out the water tank.
2. Fill the water tank with cold water up to the "max" mark.
3. Close the tank cover until you feel it engage.
4. Slide in the water tank until it engages.
Switching on the appliance
1. Press the operating mode selector to make it pop out.
The appliance switches on. "Appliance is ready for use"
appears in the text display.
2. Turn the operating mode selector until the desired operating
mode appears on the text display.
A default temperature appears on the temperature display.
3. Turn the temperature selector to change the default
temperature.
For operating modes that use steam, a default cooking time
appears in the electronic clock. The
KJ and x (cooking
time) symbols light up.
4. Turn the rotary selector to change the default cooking time.
The new cooking time is saved automatically after 3 seconds.
You can also set the cooking time for operating modes that
do not use steam (see section: Electronic clock).
5. Press the Start button.
If you do not press the Start button, a signal sounds and
"Press Start button" appears in the text display.
When
é steam cooking, the cooking time does not start until
the heating up time has elapsed.
"Fill water tank?" message
This message appears if you set an operating mode and the
water tank is only half full.
If you think that the water in the water tank is sufficient for the
cooking procedure, you can start the appliance. If not, fill the
water tank to the "max" mark, slide it back in and start the
appliance.
Heating indicator
The heating indicator displays the rising temperature in the
cooking compartment.
■ Temperature reached (fig. A)
■ Appliance reheating (fig. B)
Current temperature
Press the
± info button.
The current temperature is displayed for 3 seconds.
Displaying and changing the cooking time.
Press the
KJ clock function button repeatedly until the KJ
and
x symbols light up. The current cooking time is displayed.
Turn the rotary selector to change the cooking time. The
change is saved automatically.
Changing the temperature
You can change the temperature at any time. To change the
temperature, turn the temperature selector until the required
temperature is displayed.
Pause
Briefly press the Stop button to interrupt cooking (pause). The
cooling fan may continue running. Press the Start button to
restart.
Operating mode Temperature range
é
Steam cooking 35 - 100 °C
8
CircoSteam® 120 - 230 °C
3
Hot air 30 - 230 °C
ä
Reheat 100 - 180 °C
ê
Dough proving 35 - 50 °C
A
Defrost setting 35 - 60 °C
/
Low-tempera-
ture cooking
60 - 120 °C
P
Plate warming 30 - 70 °C
ç
Keep warm 60 - 100 °C
$ %
To Next Page
Loading...
Need help?
General
