Add-on Orbi Pro WiFi 6 AX5400 satellite LEDs
The following table describes the LED behavior for an add-on Orbi Pro WiFi 6 AX5400
satellite (model SXS50) that was purchased separately from the Orbi Pro WiFi 6 AX5400
System kit.
Table 2. Orbi Pro WiFi 6 AX5400 add-on satellite (model SXS50) LED description
LED BehaviorLED
The Power LED is located adjacent to the power port on the rear panel.
•
Solid green: Power is on.
•
Solid amber: The satellite is rebooting.
•
Blinking amber: The satellite is resetting to factory default settings.
•
Blinking red: The firmware is corrupted.
•
Off: Power is not supplied.
Power LED
Optional add-on satellites are sold separately and can be added to your Orbi network. The
bar LED is located on the front.
•
Pulsing white: The satellite is booting.
•
Solid white: The satellite is ready to sync to the router (press the Sync button).
•
Blue for three minutes: The connection between the satellite and the router is good.
•
Amber for three minutes: The connection between the satellite and the router is fair.
•
Magenta: The satellite is not connected to the router or is not getting an IP address.
•
Off: The satellite synced to the router and is working normally.
Add-on satellite
bar LED
Orbi Pro WiFi 6 AX5400 router and satellite
labels
The Orbi Pro WiFi 6 AX5400 router label shows the login information, the WiFi network
name and password, the router’s MAC address, and the router’s serial number. The
following is an example of what the router label might look like:
User Manual14Overview and Setup
Orbi Pro WiFi 6 AX5400 Router Model SXR50 and Orbi Pro WiFi 6 AX5400 Satellite Model SXS50
To Next Page
Loading...
Need help?
General
