NETGEAR Orbi User Manual

Overview
10
Orbi High-Performance AC3000 Tri-band WiFi System
Optional Orbi Add-On Satellite LEDs
You can purchase add-on Orbi satellites (sold separately) and add them to your Orbi network.
Table 2. Orbi Add-On Satellite LED description
LED LED Behavior
Power The Power LED is located above the Power On/Off button on the rear
panel.
• Solid green.Power is on.
• Solid amber. The
satellite is rebooting.
• Blinking amber. Resetting to factory default settings.
• Blinking red. The
firmware is corrupted.
• Off. Power is not supplied.
Add-On Satellite ring Optional Add-On Satellites are sold separately and can be added on to your
Orbi network.
The ring LED is located on the top.
• Pulsing white. The
satellite is booting.
• Solid white.
The satellite is ready to sync to the router (press the Sync
button).
• Blue for 3 minutes.
The connection between the satellite and the
router is good.
• Amber for 3 minutes. The
connection between the satellite and the
router is fair.
• Magenta.
The satellite is not connected to the router or is not getting an
IP address.
• Off.
The satellite synced to the router and is working normally.
Connect Your Router
 To cable your router:
1. Unplug your modem’
s power, leaving the modem connected to the wall jack for your
Internet service.
If your modem uses a battery backup, remove the battery.
2. Plug in and turn on your modem.
If your modem uses a battery backup, put the battery back in.

NETGEAR Orbi Specifications

General

Brand	NETGEAR
Model	Orbi
Category	Network Router
Language	English