Transport and storage
F2120 must be transported and stored vertically.
NOTE
Ensure that the heat pump cannot fall over
during transport.
Ensure that the heat pump cannot be damaged during
transportation.
Assembly
• Place F2120 outdoors on a solid level base that can
take the weight, preferably a concrete foundation. If
concrete slabs are used they must rest on asphalt or
shingle.
• The lower edge of the evaporator must be at the level
of the average local snow depth. The concrete
foundation or concrete plinths must therefore be at
least 70 mm high.
• F2120 should not be positioned next to noise sensitive
walls, for example, next to a bedroom.
• Also ensure that the placement does not inconveni-
ence the neighbours.
• F2120 must not be placed so that recirculation of the
outdoor air can occur. This causes lower output and
impaired efficiency.
• The evaporator must be sheltered from direct wind / ,
which negatively affects the defrosting function. Place
F2120 protected from wind / against the evaporator.
• Some water may drip from the drainage hole below
F2120. Make sure that water can run off by selecting
a suitable material underneath F2120 (see page 10).
• Care must be exercised so that the heat pump is not
scratched during installation.
Do not place F2120 directly on the lawn or other non
solid surface.
If there is a risk of snow slip from roof, a protective roof
or cover must be erected to protect the heat pump,
pipes and wiring.
9Chapter 2 | Delivery and handlingNIBE F2120
2 Delivery and handling
To Next Page
Loading...
Need help?
General
