Actions with operating disturbances
FIGHTER 1210
For the Installer
34
NOTE!
The
product’s serial number
should always be stated with all
correspondence with NIBE.
689
___________
Cause: Incorrect setting of the Curve slope and/or
Increase/reduce heat.
Action: Adjust the setting.
Cause: Large amounts of hot water were used.
Action: Wait until the water heater reheats.
Cause: Compressor and/or immersion heater does
not heat up.
Action: Check and replace blown circuitand main
fuses.
Cause: Too low start temperature setting on the
control computer
(34).
Action: Adjust the start temperature setting.
Cause: Possible earth circuit-breaker tripped.
Action: Reset the earth circuit-breaker, if the earth
circuit-breaker trips repeatedly, call an
electrician.
Cause: Compressor and electric module do not
heat.
Action: Check and replace blown circuitand main
fuses.
Cause: The compressor does not run because of a
too low set value on the control curve.
Action: Check and possibly raise Increase/reduce
heat (knob on the front panel) or Curve
slope.
Cause: The compressor standstills due to the
internal overheating protection tripping.
Action: Automatic resetting after cooling for a few
hours.
Cause: Possible earth circuit-breaker tripped.
Action: Reset the earth circuit-breaker, if the earth
circuit-breaker trips repeatedly, call an
electrician.
Low hot water temperature
or no hot water
In the event of malfunction or operating disturbances first
check the points below:
High room temperature
Low room
temperature
If the operating disturbance cannot be rectified by means of the above an installation
engineer should be called.
To Next Page
Loading...
Need help?
General
