Nice IT4WIFI User Manual

12 – English
Steady green Steady green Permanent The Accessory is correctly associated with the
Wi-Fi network via which it was congured (in the
case of MyNice technology, connection to the
Cloud is also active)
Flashing green Steady green Steady green Temporary
(a few seconds)
The Accessory is searching for the automation
associated with it
OFF OFF Green Temporary
(a few seconds)
The Accessory, already congured on the Wi-Fi
network, is starting up
OFF OFF Steady green Permanent The Accessory, if not congured on the Wi-Fi
network within 30 minutes of start-up, can no
longer receive the network conguration.
To restore it to that mode, disconnect it from the
power and then reconnect it
Green Green Green, 8 quick ashes Temporary The Accessory has undergone an “Identify” ac-
tion by the user
Green, quick ash-
ing
OFF Steady red Temporary
(roughly 30 seconds)
The Accessory is loading the conguration for
correct operation
Wait for the operation to be completed
Green Orange Green Temporary
(variable time)
In the MyNice technology, the Accessory was
unable to connect to the Cloud or has lost the
connection to the Cloud.
The Accessory automatically restores the con-
nection as soon as it becomes available
Flashing orange OFF Flashing orange Temporary
(roughly 1 minute)
The accessory is updating. Wait for the opera-
tion to be completed. If the operation is not
completed correctly, IT4WIFI automatically re-
starts after 5 minutes
Error status
L1 LED L2 LED L3 LED State Description
OFF Steady red Steady red Permanent Problem: the Accessory has not started up
correctly
Solution: try to restart the Accessory, discon-
necting it from the power and then reconnect-
ing it.
If the problem reoccurs, carry out a Reset, re-
storing the factory settings, see Table 7 - Chap-
ter 8
Steady red Permanent Problem: the Accessory has acquired an in-
correct network conguration
Solution: carry out the rst or second type of
reset detailed in Chapter 8
Steady red Permanent Problem: the Accessory has not found the au-
tomation associated with it
Solution: if present, try to install the Accessory
on another Gate&Door automation. If the prob
-
lem reoccurs, replace the cable. If the problem
persists, the Accessory or Central unit is dam
-
aged
Flashing red Permanent or tempo-
rary
Problem: the Accessory (already congured on
the network) has lost the Wi-Fi connection to
the Access Point
Solution: check that the Access Point is work-
ing and that other Wi-Fi devices are able to cor-
rectly connect to it, from the Accessory installa-
tion point. Check that the Accessory’s antenna
is correctly installed. Check that the Accessory
is not shielded by any metal object that creates
interference with the connection. If the con-
nection cannot be restored in any way (Access
Point replaced or parameters modied), carry
out a total conguration Reset or Reset the Wi-
Fi credentials, see Table 7 - Chapter 8
To check LED behaviour when the Accessory is reset, see Table 7 - Chapter 8.

Nice IT4WIFI Specifications

General

Brand	Nice
Model	IT4WIFI
Category	Recording Equipment
Language	English