Pag. 23 a 37
LP21/LP22 Installation instructions en Sensors
8.3 Reset button
The device is reset using the reset button on the front as follows:
Runs a frequency readjustment and clears the LED
fault messages
Resets the device to factory settings (DIP switch
default settings)
9 Description of settings
The functions described below can be performed with the Detector Tool service program as well as with the
DIP switch. The DIP switch provides the key default settings. Commissioning is not possible without the service
program.
• In order to reset to factory settings, hold the reset button down for 5 seconds.
Information in this column shows the settings options for the DIP switch.
Information in this document
This document refers to the default settings or default values defined by the manufacturer. The factory
settings of customer variants may differ from the manufacturer’s specifications. Please observe the
instructions on the device, as well as the documents supplied with it.
To Next Page
Loading...
Need help?
General
