4
2.2) Typical system
Figure 2 shows a typical system for automating a sliding gate using ROBUS350.
2
1 Key-operated selector switch
2 Photocells on post
3 Photocells
4 Main fixed edge (optional)
5 Main movable edge
6 “Open” stop bracket
7 Rack
8 Secondary fixed edge (optional)
9 flashing light with incorporated aerial
10 ROBUS350
11 “Closed” stop bracket
12 Secondary movable edge (option)
13 Radio-transmitter
2.3) List of cables
Figure 1 shows the cables needed for the connection of the devices in a typical installation; Table 2 shows the cable characteristics.
: the cables used must be suitable for the type of installation. For example, an H03VV-F type cable is recommended for
indoor applications, while an H07RN-F is suitable for outdoor applications.
Note 1: power supply cables longer than 30 m may be used provided they have a larger gauge, e.g. 3x2.5mm
2
, and a safety grounding sys-
tem is provided near the automation unit.
Note 2: A 2x1mm
2
cable is needed if the “BLUEBUS” cable is longer than 30 m (max. 50 m).
Note 3: A single 4x0.5mm
2
cable can be used instead of two 2x0.5mm
2
cables.
Note 4: Please refer to Chapter “7.3.2 STOP Input” in situations where there is more than one edge, for information about the type of con-
nection recommended by the manufacturers.
Note 5: special devices which enable connection even when the leaf is moving must be used to connect movable edges to sliding leaves.
Connection Cable type Maximum length allowed
A: Power line N°1 3x1.5mm
2
cable 30m (note 1)
B: Flashing light with aerial
N°1 2x0 5mm
2
cable 20m
N°1 RG58 type shielded cable 20m (recommended less than 5m)
C: Photocells N°1 2x0.5mm
2
cable 30m (note 2)
D: Key-operated selector switch N°2 2x0.5mm
2
cables (note 3) 50m
E: Fixed edges N°1 2x0.5mm
2
cable (note 4) 30m
F: Movable edges N°1 2x0.5mm
2
cable (note 4) 30m (note 5)
Table 3: list of cables
The installation of ROBUS350 must be carried out by qualified personnel in compliance with current legislation, standards
and regulations, and the directions provided in this manual.
To Next Page
Loading...
Need help?
General
