14
First Steps
First Steps
Inserting the Batteries
1 Open the battery-chamber/memory card slot
cover.
Before opening the battery-chamber/memory card slot cover,
hold the camera upside down to prevent the batteries from
falling out.
The camera, batteries or memory card may be hot
immediately after using the camera. Observe caution when
removing the batteries or memory card.
2 Insert the Batteries
Confirm that the positive (+) and negative (-) terminals are
oriented correctly as described on the label at the entrance of
the battery chamber, and insert the batteries.
3 Close the battery-chamber/memory card slot
cover.
Slide the cover while securely holding down the area marked
2.
Applicable Batteries
• Four LR6/L40 (AA-size) alkaline batteries (batteries supplied)
• Four FR6/L91 (AA-size) lithium batteries
• Four EN-MH2 rechargeable Ni-MH (nickel metal hydride) batteries
* EN-MH1 rechargeable Ni-MH batteries cannot be used.
Turning On and Off the Camera
Remove the lens cap, and then press the power switch
to turn on the camera. The power-on lamp (green) will
light, and then the monitor will turn on (the power-on
lamp turns off when the monitor turns on).
Press the power switch again to turn the camera off.
When the camera turns off, both the power-on lamp
and monitor turn off.
If the camera is turned off, hold down the c button
to turn the camera on in playback mode (A 26).
1
3
2
1
3
2
To Next Page
Loading...
Need help?
Power
Display
Camera Specifications
Weight and Dimensions
