18
First Steps
Inserting Memory Cards
Data is saved in the camera’s internal memory (approximately 102 MB) or on
removable Secure Digital (SD) memory cards (commercially available; (A 129).
If a memory card is inserted into the camera, images are automatically saved on
the memory card and images saved to the memory card can be played back,
deleted or transferred. Remove the memory card to save images in the internal
memory, or play back, delete or transfer images from the internal memory.
1 Confirm the power-on lamp and the monitor
are off and open the battery-chamber/
memory card slot cover.
Be sure to turn off the camera before opening the
battery-chamber/memory card slot cover.
Before opening the battery-chamber/memory card slot
cover, hold the camera upside down to prevent the
batteries from falling out.
2 Insert the memory card.
Slide the memory card in until it clicks into place.
B Inserting Memory Cards
Inserting the memory card upside down or backwards
could damage the camera or the memory card. Make
sure that the memory card is correctly oriented.
3 Close the battery-chamber/memory card slot cover.
Removing Memory Cards
Turn the camera off and be sure that the power-on
lamp and the monitor have turned off before opening
the battery-chamber/memory card slot cover.
Press the card in (1) to partially eject the card, then
remove the card by hand while being careful not to
remove it at an angle (2).
• The camera, battery or memory card may be hot
immediately after using the camera. Observe caution
when removing the batteries or memory card.
1
3
2
12
To Next Page
Loading...
Need help?
Power
Display
Camera Specifications
Weight and Dimensions
