20 21
En
Fr
Es
Pt
En
Fr
Es
Pt
￭ Troubleshooting/Repair
If the Nikon Laser Rangefinder fails to function as expected, check the list below before consulting
your local dealer or the store where you purchased it.
● If there is a problem with the product.
Problem Cause/Solution
・Does not turn on
・Press the PWR button (top of the body).
・Check battery is inserted correctly.
・Replace the battery with a new one.
・Unable to measure
・Anomalous result
・Confirm each mode setting.
・Confirm if it can measure a large target close to you (example: a building
approx. 15m/yd. ahead of you).
・Clean the lens surface if necessary.
・Do not know if VR
(Vibration Reduction)
function is working
・Compare the vibration of the target in the viewfinder when the Laser
Rangefinder is ON and OFF.
・ While the Laser Rangefinder is ON, the VR (Vibration Reduction) function is
always activated.
・ Cannot turn off the VR
(Vibration Reduction)
function
・The VR (Vibration Reduction) function is activated concurrently when the
Laser Rangefinder is ON. When the Laser Rangefinder is OFF, the VR (Vibration
Reduction) function automatically turns off.
・The VR (Vibration Reduction) function cannot be switched on and off.
・There are minute motion
sounds when the power
turns on and off
・Due to the VR (Vibration Reduction) system motor, minute motion sounds
occur. These sounds are normal, please continue to use the Laser Rangefinder.
・[
] is displayed in the
internal display
・ Failure indication. Please contact your local dealer or the store where you
purchased the product.
● If you require a repair, please contact your local dealer or the store where you purchased the product.
Do not repair or disassemble. It may result in a serious incident.
Please note that Nikon is not responsible for any direct or indirect damage if the user attempts repair
or disassembly.
To Next Page
Loading...
Need help?
General
