Nokia FastMile 4G Installation Guide

Nokia FastMile 4G Receiver Installation Guide Reviewing safety information
Issue: 01 3TG-00387-ABBA-TCZZA 31
6 Reviewing safety information
6.1 Safety information for the Nokia FastMile 4G Receiver
6.2 Available PoE injectors
6.1 Safety information for the Nokia FastMile 4G
Receiver
Be sure to observe the following before installing the Nokia FastMile 4G Receiver:
• Professional installation is recommended for the Nokia FastMile 4G Receiver. If
the end-user is going to install the Nokia FastMile 4G Receiver, appropriate safety
instructions and appropriate information must be provided.
• Only use a Nokia-approved residential gateway or a Nokia-approved PoE injector
for powering the Nokia FastMile 4G Receiver.
• The following classes of PoE injectors are available from Nokia for use with the
FastMile 4G Receiver:
• Class I: can comply with EN 60950-1 if grounding is provided on the wall socket;
should be put as close as possible to the place where the Ethernet cable enters the
home; see section 6.2 for information about the Class I PoE injectors that are
available from Nokia.
• Class II: can comply with EN 60950-1 if no grounding is provided on the wall socket;
can also be used if grounding is provided on the wall socket; see section 6.2 for
information about the Class II PoE injectors that are available from Nokia
• Refer to section 8.2.1 for lightning protection and other important information.
• Do not provide power to the Nokia FastMile 4G Receiver before completing the
hardware installation steps of the installation procedure except as directed.
• All outside wiring associated with the Nokia FastMile 4G Receiver should follow
local safety regulations.
• Maintain at least 50 cm (20 in) distance from the front face of the Nokia FastMile
4G Receiver while the system is operating.

Nokia FastMile 4G Specifications

General

Brand	Nokia
Model	FastMile 4G
Category	Receiver
Language	English