Nokia WiFi Gateway 3 Product Guide ETSI CPE safety guidelines
Issue: 01 3FE-47464-AAAA-TCZZA 25
3.2.1 EMC, EMI, and ESD compliance
The customer premises equipment complies with the following EMC, EMI, and ESD
requirements:
• EN 300-386 V1.6.1: Electromagnetic Compatibility and Radio Spectrum Matters
(ERM): Telecommunications Network Equipment; Electromagnetic Compatibility
(EMC) requirements; Electrostatic Discharge (ESD) requirements
• EN 301489-1: Electromagnetic Compatibility and Radio Spectrum Matters (ERM):
Telecommunications Network Equipment; Electromagnetic Compatibility (EMC)
Standard for Radio Equipment and Servcies; part 1: Common Technical
Requirements
• EN 301489-17: Electromagnetic Compatibility and Radio Spectrum Matters
(ERM); Electromagnetic Compatibility (EMC) Standard for Radio Equipment; Part
17: Specific Conditions for Broadband Data Transmission Systems.
• Radio Equipment Directive (RED) 2014/53/EU (applicable from 13 June 2016)
• EN 55032 (2015): Electromagnetic compatibility of multimedia equipment -
Emission Requirements
• EN 55024 (2010): Information Technology Equipment, Immunity Characteristics,
limits and methods of measurement
• Electromagnetic Compatibility (EMC) directive 2014/30/EU
• European Council Directive 2004/108/EC
• Low Voltage (LVD) directive 2014/35/EC
3.2.2 Equipment safety standard compliance
The customer premises equipment is labeled with specific safety compliance
information and instructions that are related to a variant of the CPE. Observe the
instructions on the safety labels.
Table 3 provides examples of the text in the various CPE safety labels.
Table 3 Safety labels
Figure 2 shows a sample safety label located on the bottom of the Gateway 3
(G-240W-E).
Label text Description
TUV compliance Type 3R enclosure - Rainproof.
ESD warning Caution: This assembly contains electrostatic sensitive device.
CDRH compliance Complies with 21 CFR 1040.10 and 1040.11.
CE marking There are various CE symbols for CE compliance.
To Next Page
Loading...
Need help?
General
