Install a Gateway 3 (G-240W-E)
50
Nokia WiFi Gateway 3 Product Guide
3FE-47464-AAAA-TCZZA Issue: 01
i Remove the fiber optic connection cover (white cylinder), as shown in Figure 9.
Figure 9 Gateway 3 (G-240W-E) cylinder removal
ii Detach the bottom cover.
iii Plug the fiber optic cable with the SC/APC adapter into the fiber optic connector, as
shown in Figure 9.
iv Wind the fiber optic cable through the fiber track at the base of the cylinder until the
desired length of the cable is reached.
v Press the fiber optic cable into the slot.
vi Replace the bottom cover.
vii Replace the fiber optic connection cover (white cylinder).
3 Review the connection locations, as shown in Figure 10.
Note — Fiber cable preparation varies depending on the type and size
of the inside or outside plant fiber cable being spliced to the SC/APC fiber
optic pigtail cable.
Fiber raceway
Cylinder
Bottom cover
Fiber optic cable
and connector
28292
To Next Page
Loading...
Need help?
General
