Product Overview
12 PN 15842:K 7/23/2002
Section 2 Product Overview
This section is intended as a basic inventory of components that can be used in
an ACS system. For system design considerations, see Section 3. For
installation, configuration and programming instructions, see Section 4. For
LED and Switch functions instructions, see Section 5.
2.1 ACM-24AT and AEM-24AT
Annunciator Control Module
The rubber keypad of the ACM-24AT has 24
annunciator points, each with a touch-pad switch and
two LEDs: the point-active LED can be programmed
for red, green, or yellow
*
; the point-trouble LED is
yellow. The keypad has a system trouble LED, an
On-line/Power LED, and a local piezo sounder with a
silence/acknowledge switch for audible indication of
alarm and trouble conditions at each annunciator.
Height = 8.375" (21.27 cm), Width = 4.37" (11.10
cm).
Expander
The AEM-24AT is an expander board for the ACM-24AT with an additional 24
switched and controlled annunciator points. An ACM-24AT can support one,
two, or three expanders at the same address, to a maximum of 96 system points.
Note: The AEM-24AT cannot be used to expand the ACM-48A, ACM-16AT
series, or ACM-32A series.
2.2 ACM-48A and AEM-48A
Annunciator Control Module
The rubber keypad of the ACM-48A has 48
annunciator points, each with a point-active LED that
can be programmed for red, green, or yellow*. The
keypad has a system trouble LED, an On-line/Power
LED, and a local piezo sounder with a silence/
acknowledge switch for audible indication of alarm
and trouble conditions at each annunciator. Height =
8.375" (21.27 cm), Width = 4.37" (11.10 cm).
Expander
The AEM-48A is an expander board for the
ACM-48A with an additional 48 switched and
controlled annunciator points. An ACM-48A can support one expander at the
same address for a maximum of 96 system points. Note: The AEM-48A cannot
be used to expand the ACM-24AT, ACM-16AT series, or ACM-32A series.
* Check local regulations when programming colors; some jurisdictions restrict color
choice. For example, in Canada red indicates active alarm inputs; yellow indicates
supervisory, burglary or trouble signals; green indicates the presence of power, or an
activated output.
acm-24atface.cdr
ACM-48-face.cdr
To Next Page
Loading...
Need help?
General
