NSI DS12 User Manual

NSI DS8/DS12 MODULAR DIGITAL DIMMING SYSTEM
Software Revision 1.1x, 8/24/99
- 5 -
________________________________________________________________
Control Wiring
DMX-512: Input = 5 pin XLR-M Pin# Signal
Through Output = 5 pin XLR-F 1 DGND
2 DATA -
Recommended 3 DATA +
Control Wire: 4 THROUGH
Belden 9729 or 9829 5 THROUGH
Microplex: Input = 3 pin XLR-M Pin# Signal
(MPX) Through Output = 3 pin XLR-F 1 Analog COM
2 +14.4VDC Power
Recommended 3 DATA
Control Wire:
Belden 8760 or 9460
0-10VDC: Input = 15 pin M D-Sub Pin# Signal
Analog 1 Channel 1
Recommended 2 Channel 2
Control Wire: 3 Channel 3
Alpha 1896 4 Channel 4
5 Channel 5
6 Channel 6
7 Channel 7
8 Channel 8
9 Channel 9
10 Channel 10
11 Channel 11
12 Channel 12
13 T/C (Snapshot)
14 +14.4VDC Power
15 Analog COM
Luma-Net Input = 6 pin pluggable terminal block Pin# Signal
Orientation: looking at back of pack, 1 (far right) REM +
with grooved surface on bottom. 2 REM -
3 DGND
Recommended 4 +14.4VDC Power
Control Wire: 5 N/C
Alpha 1898 6 (far left) N/C
IMPORTANT NOTE: Do not route low voltage control wires parallel to or in the same conduit as high voltage
power wires as the control system may exhibit erratic control performance. (like flickering)

NSI DS12 Specifications

General

Brand	NSI
Model	DS12
Category	Dimmer
Language	English