NSI DS8/DS12 MODULAR DIGITAL DIMMING SYSTEM
Software Revision 1.1x, 8/24/99
- 8 -
2.3 Test Switch Action / Level Selection:
From the main menu:
NSI DSxx xPHASE Note: the 'x's could indicate a variety of settings
STATUS=xxx [MORE]
Press the key sequence [MORE], [MORE], [SETUP], [MORE] [MORE]. The following menu will be displayed:
SET TEST SWITCH
[ACTION] [MORE]
Select [ACTION]. The following menu will be displayed:
SWITCH ACTION =
[LATCH] [BUMP]
If you select [LATCH], the dimmer channel will toggle between the bump level and off each time the test switch
under the circuit breaker is pressed. If you select [BUMP], the dimmer channel will turn on only while the test switch
is being pressed. After selecting the test switch action, the following menu will appear:
SET TEST LVL = 25%
[CHANGE] [MORE]
If you wish to change the test switch bump level, press change, then enter the 'on' control level you wish the
channels to bump or latch to. Note: the bump level selection is only stored in ram, so it will default back to 25%
when the pack is powered off.
2.4 Analog Input Defaults Selection:
The 0-10VDC analog inputs on this DS dimmer pack do not have to be just 0-10VDC control inputs for single
channel dimmer control. The analog inputs can also operate as overlapping submaster scenes with time fade
damping, or trigger inputs to linked presets that can operate in a chase pattern on one of the analog submasters. To
program these functions, refer to the Analog Submaster section of this manual. Enabling [DEFAULTS] in this
menu will erase all the submaster scenes and their fade times, and re-program all inputs to a 1 to 1 patch with
0 time fade damping. ( analog input 1 = channel 1, analog input 2 = channel 2, … analog input 12 = channel 12 ).
From the main menu:
NSI DSxx xPHASE
STATUS=xxx [MORE]
Press the key sequence [MORE], [MORE], [SETUP], [MORE], [MORE], [MORE], [MORE]. The following
menu will be displayed:
SET ANALOG INPUT
[DEFAULTS] [MORE]
If you wish to re-patch all the analog inputs back to a 1:1 patch, press [DEFAULTS]. The following menu will
appear:
ARE YOU SURE? IF
SO PRESS [ENTER]
If you are not sure, press any key except [ENTER] to return to the previous menu. If you are sure, press [ENTER],
and a brief message of " WRITING DATA …" will be displayed.
To Next Page
Loading...
Need help?
General
