To Next Page

To Previous Page

ML690/ML691 User’s Guide 23

TEAR and LF/FF keys at the same time, then

release the keys.

Continue until the tear-off perforations have been

aligned with the paper cutter.

When data is received by the printer or when the SEL

key is pressed to select the printer, the paper will

retract to the new position.

Removing Continuous Forms Paper

Tear off the continuous forms.

Press the LOAD/EJECT key to move the front edge

of the continuous forms backwards to the Pin

Tractors.

NOTE:

The printer switches to ofine mode. The

ALARM indicator illuminates to indicate that

there is no paper present. If sprocket holes

of the last page of the forms disengage from

the sprocket pins, do not attempt to eject the

paper to avoid the possibility of a paper jam.

Lift the pin tractor covers and remove the forms.

Close the pin tractor covers.

Loading Cut Sheet Paper

There are two methods of loading single sheets of

cut sheet paper, top feed and front feed. See the

following pages for instruction.

Cut Sheet Paper, Top and Front Feed

Make sure the printer is turned ON.

Note: If there is any continuous forms paper in the

printer, eject it as described in “Removing

Continuous Forms Paper”.

Make sure that the Pin Tractor covers are closed to

avoid the possibility of paper jams.

Place the Paper Type lever in the cut sheet position:

To load the cut sheet in the Top Feed Paper tray,

raise the top tray.

To load the cut sheet in the Front Feed Paper tray,

open the front cover and install the front paper tray.

Oki ML690 User Manual

Other manuals for Oki ML690