ML690/ML691 User’s Guide 30
Resetting Top of Form to the Factory
Default
The factory default setting for the Top of Form
(where the printing should begin) is 11/12”
(23.28 mm) down from the top of the page.
To reset the Top of Form to the factory default:
Remove paper from the paper path.
Turn the printer off.
Press and hold LF/FF + TEAR while turning on the
printer.
Reload paper.
1.
2.
3.
4.
Temporarily Changing the Top of Form
Position
Important
Do not use the platen knob to change the Top of Form.
If you turn the platen knob when the printer is turned
ON, the Top of Form misaligns. Always turn the printer
OFF before turning the platen knob!
To move the Top of Form position lower for one page
only:
Press SEL to deselect the printer.
Press LF to lower the position of the Top of Form.
1.
2.
To Next Page
Loading...
Need help?
General
