14
2.Preparation
Setting the Buzzer
1. While in the setting mode, press
the SET button until the buzzer
symbol ( ) appears on the
display.
Note: The default setting is
“on1” or “on”, depending
on the Positioning
indicator you set.
2. Press the MEM button to select the buzzer setting.
If the Positioning indicator is “on1” or “on2”:
on1: The buzzer sounds only when the monitor is in
proper position.
on2: The buzzer sounds a series of two short blips if your
wrist is too far away from the measuring position,
and beeps when your wrist is in the proper position.
oFF: The buzzer will not sound.
If the Positioning indicator is “oFF”:
on: The buzzer sounds when pressing any buttons.
oFF: The buzzer will not sound.
Resetting to the Default Setting
The positioning indicator is set “on1”, the wrist for measurement
is set “ ”, and the buzzer is set “on1” as default.
To reset to the default setting, press and hold the SET button
while in the setting mode, then press the START/STOP button
simultaneously for more than 2 seconds.
HEM-6052-C1_B_M.fm Page 14 Tuesday, March 9, 2010 9:15 AM
To Next Page
Loading...
Need help?
General
