20
3. Using the Unit
3.3 Taking a Reading
The unit is designed to take measurements and store the
measurement values in the memory for two people using user
ID A and user ID B.
The unit can also be used to take a single measurement for
other persons using the guest mode. The user ID symbol is
not displayed when using the guest mode. Measurements
taken using the guest mode are not stored in the memory.
Using the Guest Mode
1. Press and hold the START/STOP button until the A and B
user symbols disappear from the display.
2. Release the START/STOP button.
The cuff starts to inflate automatically.
Note: To stop the inflation press and release the START/
STOP button. The unit will stop inflating, start
deflation and turn off.
3. Inflation stops and the measurement is started. When the
measurement is completed, your blood pressure and
pulse rate appear on the display.
Press for at least 3 seconds
A and B display goes
out
HEM-7080-C1_B_M.fm Page 20 Tuesday, March 9, 2010 9:05 AM
To Next Page
Loading...
Need help?
General
