21
3. Using the Unit
Selecting the User ID
Select your user ID. Always use the same user ID when
taking a measurement. The unit stores the measurement
values in the memory by the user ID selected. These
measurement values are used to calculate the morning
averages and evening averages.
Slide the user ID selection switch up or down to select user A
or B.
Using the User ID
When you select a user ID the unit can be set to take one
measurement using the single mode or three consecutive
measurements using the auto mode when you press the
START/STOP button.
Note: The default value is set to the single mode to take
one measurement.
The auto mode takes three consecutive measurements. The
unit will inflate the cuff and take three measurements
separated by a short interval of time between each
measurement.
HEM-7080-C1_B_M.fm Page 21 Tuesday, March 9, 2010 9:05 AM
To Next Page
Loading...
Need help?
General
