Omron NX-EC0222 User Manual

6 Incremental Encoder Input Units
6 - 42
NX-series Position Interface Units User’s Manual (W524)
The big configuration of the Preset Command Value parameter is given in the following table.
n: Channel number
Use the Incremental Encoder Input Unit as an encoder axis when you use the MC Function Module in
an NJ/NX-series Controller.
For information on axis parameters and how to assign axis variables, refer to the NJ/NX-series CPU
Unit Motion Control User’s Manual (Cat. No. W507).
LSEL1n
Latch Input 1 Trigger Selection
*1
0: External input
1: Phase-Z input
LEN2n Latch Input 2 Enable 1: Enable the latch input 2.
0: Disable the latch input 2.
LTRG2n
Latch Input 2 Trigger Condition
*2
0: One-shot Mode
1: Continuous Mode
LSEL2n
Latch Input 2 Trigger Selection
*2
0: External input
1: Phase-Z input
*1. The setting is enabled when the Latch Input 1 Enable bit changes from 0 to 1.
*2. The setting is enabled when the Latch Input 2 Enable bit changes from 0 to 1.
Preset Command Value
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 PSVn (Chn Preset Command Value LL)
+1 PSVn (Chn Preset Command Value LH)
+2 PSVn (Chn Preset Command Value HL)
+3 PSVn (Chn Preset Command Value HH)
Abbr. Data Description
PSVn Chn Preset Command Value This contains the preset command value for channel n.
6-7-3 Axis Settings
Abbr. Data Description

Omron NX-EC0222 Specifications

General

Brand	Omron
Model	NX-EC0222
Category	Controller
Language	English