Omron NX-EC0222 User Manual

10 Troubleshooting
10 - 12
NX-series Position Interface Units User’s Manual (W524)
Event name Control Parameter Error in Master Event code 10410000 hex
Meaning An error occurred in the control parameters that are saved in the master.
Source
Depends on where the Sysmac
Studio is connected and the sys-
tem configuration.
Source details
NX Unit
Detection
timing
When power is
turned ON to
the NX Unit
Error
attributes
Level
Minor fault
Recovery
When the
fail-soft opera-
tion for the
Communica-
tions Coupler
Unit is set to
stop, restart the
NX Unit and
then reset all
errors in Con-
troller.
When the
fail-soft opera-
tion for the
Communica-
tions Coupler
Unit is set to
fail-soft, restart
the NX Unit and
then reset
errors in Com-
munications
Coupler Unit.
Log category
System
Effects User program Continues. Operation I/O refreshing for the NX Unit stops.
Sys-
tem-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
There is an error in the area of the
non-volatile memory in the Com-
munications Coupler Unit in which
the Unit operation settings for the
NX Unit are saved.
Download the Unit operation set-
tings of the NX Unit again and
restart the Communications Cou-
pler Unit.
If the error occurs again even after
you make the above correction,
replace the Communications Cou-
pler Unit.
Do not turn OFF the power supply
to the NX Unit or disconnect Sys-
mac Studio communications while
transfer of the Unit operation set-
tings for the NX Unit or execution
of the NX_SaveParam instruction
is in progress.
The power supply to the NX Unit
was turned OFF or Sysmac Studio
communications were discon-
nected while writing the Unit oper-
ation settings was in progress.
Attached
information
None
Precautions/
Remarks
None

Omron NX-EC0222 Specifications

General

Brand	Omron
Model	NX-EC0222
Category	Controller
Language	English