Omron NX-SL series User Manual

21
Unit Versions
NX-series Safety Control Unit Instructions Reference Manual (Z931)
• Hardware version
• Software version
The software version is displayed only for Units that contain software.
The functions that are supported depend on the unit version of the Unit. The version of Sysmac Studio
that supports the functions that were added for an upgrade is also required to use those functions.
Refer to the NX-series Safety Control Unit User’s Manual (Cat. No. Z930) for the relationship between
the unit versions of the CPU Units and the Sysmac Studio versions, and for the functions that are sup-
ported by each unit version.
In this User’s Manual, unit versions are specified as shown in the following table.
Unit Versions and Sysmac Studio Versions
Unit Version Notation
Unit version in Unit specifications
on the product
Notation in this manual Remarks
Ver. 1. or later Unit version 1.0 or later Unless unit versions are specified, the infor-
mation in this manual applies to all unit ver-
sions.

Omron NX-SL series Specifications

General

Brand	Omron
Model	NX-SL series
Category	Control Unit
Language	English