Omron R88D-1SN ECT Series Startup Guide

26
Disconnect from the controller
3.5 Creating motion axes
This section describes how to add axes used to control Servo Drives. Axes will be created based on
detected Servo Drives.
1.
Right click on the Master and select Assign Drives to Axes
Confirm axes allocation by clicking the Yes Button
Confirm the list of Axes added and Click the Ok Button

Omron R88D-1SN ECT Series Specifications

General

Brand	Omron
Model	R88D-1SN ECT Series
Category	Controller
Language	English