Onkyo A-9110 User Manual

6
Before use
1. SPEAKERS terminals: Connect speakers with speaker
cables. (p9)
0 North American models are banana plug ready. Use
plugs with a diameter of 1/8" (4 mm).
0 Not all models support connection with Y plugs.
2. Power cord (p12)
3. GND terminal: The ground wire of the turntable is
connected.
4. PHONO MM jacks: Use an Analog audio cable to connect
a Turntable that uses an MM type cartridge. (p11)
5. LINE IN jacks: Input audio signals from a playback device
with an analog audio cable. (p10)
6. LINE OUT jacks: Use an Analog audio cable to output
audio signals to recording equipment, such as a cassette
tape deck. To select the input source for recording, use
the INPUT dial on this unit or use the remote controller.
7. SUBWOOFER PRE OUT jack: Connect a powered
subwoofer with a subwoofer cable. (p10)
8. RI REMOTE CONTROL jack: This jack is for linking when
you connect an Onkyo CD player, tuner, network audio
player, or RI dock that has an RI (“Remote Interactive”)
jack. (p11)
Rear Panel

 
 
SN29403405_A-9110_En_1806XX.book 6 ページ ２０１８年７月５日 木曜日 午後２時４３分

Onkyo A-9110 Specifications

General

Output level	4 mV
Amplifier class	-
Frequency range	20 - 20000 Hz
Output impedance	4 Ω
Input sensitivity	200 mV
Audio output channels	2.0 channels
Peak power per channel	100 W
Signal-to-Noise Ratio (SNR)	103 dB
Total Harmonic Distortion (THD)	0.05 %
Dynamic power per channel (3 Ohm)	220 W
Dynamic power per channel (4 Ohm)	190 W
Dynamic power per channel (8 Ohm)	110 W
DC-in jack	Yes
Audio (L/R) in	4
Audio (L/R) out	1
Headphone connectivity	6.3 mm
Speakers connectivity type	Banana connector
Purpose	Home
Impedance	47 Ω
Product color	Black
Volume control	Rotary
Connectivity technology	Wired
AC input voltage	220 - 230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	130 W
LED indicators	Status
Package weight	9000 g

Weight and Dimensions

Depth	330 mm
Width	435 mm
Height	129 mm
Weight	7000 g