En-17
Connecting the Power Cord
Notes:
• Before connecting the power cord, complete and double-check all other connections.
• Turning on the CBX-500/CBX-600UKD may cause a momentary power surge that might interfere with other elec-
trical equipment on the same circuit. If this is a problem, plug the CBX-500/CBX-600UKD into a different branch
circuit.
• Do not use a power cord other than the one supplied with the CBX-500/CBX-600UKD. The supplied power cord is
designed exclusively for use with the CBX-500/CBX-600UKD and should not be used with any other equipment.
• Never disconnect the power cord from the CBX-500/CBX-600UKD while the other end is still plugged into a wall
outlet. Doing so may cause an electric shock. Always disconnect the power cord from the wall outlet first, and then
the CBX-500/CBX-600UKD.
1
Connect the supplied power cord to the CBX-500/CBX-600UKD’s AC INLET.
2
Plug the power cord into a suitable wall outlet.
The STANDBY indicator lights up.
For the AccuClock function to work properly, the unit must be able to receive RDS radio stations, which means an FM
antenna must be connected. Be sure to connect an FM antenna before plugging in the power cord (see page 14).
The very first time you plug the power cord into a wall outlet, the AccuClock function automatically searches for an
RDS radio station that’s broadcasting CT (Clock Time) information and sets the clock accordingly. While the CT infor-
mation is being received, “AccuClock…” appears dimly on the display, as shown. Note that it may take several minutes
to set the clock.
If the clock is set successfully, the day and time will be displayed brightly for 2 seconds, as shown.
The AccuClock function automatically updates the clock daily at 2, 3 , and 14.
If for some reason the clock cannot be set automatically, see “Setting the Clock” on page 45.
AccuClock—Automatic Clock Setting (CBX-500 European model and
CBX-600UKD)
To Next Page
Loading...
Need help?
General
