24
En
■ Standby power consumption
■ Pairing the controller and the
subwoofer
Tip
• If the controller is turned off or enters the standby
mode, also the subwoofer enters the standby mode
in 30 seconds. In this mode, the controller
automatically detects a pairing point and
reconnects. The subwoofer is automatically turned
on when the link is recovered.
Note
• Depending on the reception condition, the sound
might be stopped or interrupted while using. This is
not a malfunction. In this case, change the place or
direction of the controller or the subwoofer.
• If the controller and the subwoofer are too far, the
reception might be unstable. They should be placed
within 32 ft. (10 m).
• If there is an obstacle (metal door, concrete wall and
insulation contained aluminum foil, etc.) between
the controller and the subwoofer, it might block the
reception and stop the sound. Place the controller
and the subwoofer in good visibility with each
other.
Others
When the Auto Power On function is set
to “on”, the power consumption in ready
mode may reach up to a maximum of
4W.
—
Turn on the controller before performing
a pairing.
1
Press and hold LINK on the rear panel of
the subwoofer for five seconds.
Flashing speed of the LINK LED is
changed.
2
Press and hold 8ON/STANDBY on the
controller for three seconds until the
ON/STANDBY LED flashes white.
The controller and the subwoofer starts
pairing. The ON/STANDBY LED flashes
white twice indicating that the pairing is
completed.
The controller contains a microcomputer for
signal processing and control functions. In
very rare situations, severe interference,
noise from an external source, or static
electricity may cause it to lockup. In the
unlikely event that this happens, unplug the
power cord from the wall outlet, wait at least
five seconds, and then plug it back in.
Onkyo is not responsible for damages (such
as CD rental fees) due to unsuccessful
recordings caused by the unit’s malfunction.
Before you record important data, make sure
that the material will be recorded correctly.
Before disconnecting the power cord from
the wall outlet, set the controller to standby.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
