HT-R592/ 2295
DEBUG MODE-1
AUDIO DEBUG MODE-1/3
To set in Debug mode
1. Press and hold down DISPLAY button, then press ON/STANDBY button.
D1.00/13125aLA
M1.00/13302ALU
AUDIO dubug mode
4D48K1N 0FFPo0
e.g.
The version number of microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
Exit
e.g.
e.g.
e.g.
2. Press + (TONE) button while the version number of microprocessor is displayed.
3. Press DISPLAY button while the version number of DSP is displayed.
4. Press DISPLAY button.
Contents of Display
Number of digits -->
FL Display (e.g.)
Number of
digits
Contents State
1 DIR INPUT LOCK/UNLOCK E:UNLOCK
:LOCK
2 DIR INPUT RX
0:None
1:COAX1
2:COAX2
3:OPT1
4:OPT2
5:FRONT
8:HDMI1
9:HDMI2
3 DIR/ADC,FIX MODE D:Digital(SPDIF)
A:Analog
M:AnalogMultich
p:PCM FIXED
d:DTS FIXED
4-6 Sampling Freq,Emphasis 32K: 32 kHz w/o Emphasis
44K: 44.1kHz w/o Emphasis
48K: 48 kHz w/o Emphasis
64K: 64 kHz
88K: 88.2kHz
96K: 96 kHz
176:176.4kHz
192:192 kHz
32e: 32 kHz w Emphasis
44e: 44.1kHz w Emphasis
48e: 48 kHz w Emphasis
7 DIR DETECT TYPE 0:Analog
1:PCM
2:Not PCM
3:Data
4:DTS CD(Not used)
5:Multich
6:Not Decided
8 CODEC CLOCK MODE N:Normal
U:Up Sampling
H:High Sampling(Double Rate)
D:Down Smapling
Q:Quad Rate
10 DSP PORT bit0:NIC
bit1:DEC
bit2:BUSY
bit3:EXEC WAIT
Refer to "NIC DEC SPI Busy Ecec wait"
in DEBUG MODE-2
11-12 DSP SEQUENCE 00-FE:NotFree
2D:Mute Control
FF:Free
Refer to "DSP Sequence" in
DEBUG MODE-3
13 DSP DETECT FORMAT P:PCM(Analog)
D:Dolby Digital
d:DTS
A:AAC
d:DTS
A:AAC
S:DSD
p:DolbyDigital+
T:TrueHD
H:DTSHD High Resolution
M:DTSHD MaterAudio
?:UNKNOWN
14 DSP DECODE OK o:OK
x:NG
15 Mute 1:Selector
2:Effector
4:DSP
8:DIR
4 D 4 8 K 1 N 0 F F P o 0
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
To Next Page
Loading...
Need help?
General
