EasyManuals Logo
Home>Onkyo>Receiver>TX-SR606

Onkyo TX-SR606 User Manual

Onkyo TX-SR606
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background image
70
Adjusting the Listening Modes
—Continued
Audyssey Dynamic EQ
DynamicEQ
With Audyssey Dynamic EQ, you can enjoy great sound
even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorat-
ing sound quality as volume is decreased by taking into
account human perception and room acoustics.
It does so by selecting the correct frequency response
and surround volume levels moment-by-moment so that
the content sounds the way it was created at any volume
level--not just at reference level.
Off:
Audyssey Dynamic EQ off.
On:
Audyssey Dynamic EQ on.
Note:
Audyssey Dynamic EQ can be set only when the
Equalizer Settings on page 76 are set to Audyssey.
Music Optimizer
M.Optimizer
The Music Optimizer function enhances the sound qual-
ity of compressed music files. Use it with music files that
use “lossy” compression, such as MP3.
Off:
Music Optimizer off (default).
On:
Music Optimizer on.
Note:
The Music Optimizer function only works with PCM
digital audio input signals with a sampling rate below
48kHz and analog audio input signals. The Music
Optimizer is disabled when the Pure Audio or Direct
listening mode is selected.
Speaker Levels
You can adjust the volume of each speaker while listen-
ing to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to Standby.
Subwoofer
You can adjust the level from –15 dB to +12 dB.
Center
You can adjust the level from –12 dB to +12 dB.
Notes:
•You cannot use this function while the AV receiver is
muted.
Speakers that are set to No or None in the Speaker
Configuration cannot be adjusted (see page 72).
This setting is not available when the Pure Audio lis-
tening mode is used, or the Direct listening mode is
used with an analog input signal.
A/V Sync
A/V Sync
When using progressive scanning on your DVD player,
you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the
audio signals. You can set it from 0 to 100 milliseconds
(ms) in 10 millisecond steps.
TX-SR606En.book Page 70 Friday, May 9, 2008 1:28 PM

Table of Contents

Other manuals for Onkyo TX-SR606

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo TX-SR606 and is the answer not in the manual?

Onkyo TX-SR606 Specifications

General IconGeneral
Frequency range50 - 100000 Hz
Audio output channels7.1 channels
Signal-to-Noise Ratio (SNR)106 dB
Total Harmonic Distortion (THD)0.08 %
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Radio Data System (RDS)Yes
Connectivity technologyWired
Product colorSilver
Dimensions (WxDxH)435 x 374.7 x 174.3 mm
Power consumption (typical)550 W
Weight and Dimensions IconWeight and Dimensions
Weight11400 g

Related product manuals