USER MANUAL
V1.0
14 15
BATTERY COVER INSTALLATION
The battery cover is made of solid bamboo and should be handled with extreme care.
Below are the steps for proper installation of the cover so you do not break the cover.
Never force, pry, or hit the cover or you could cause major damage to the wood.
STEP 1: Place the front of the cover as far
forward as possible with the sides under
the top triple clamp. Make sure the top
of the cover is on top of the fork nut.
STEP 3: Lower the front of the cover
down and slide the cover as far back as
possible so that the front tongue latch
can clear the front latch plate.
STEP 2: Gently bring down the back of
the cover over the battery chassis panel
while doing your best to avoid hitting the
seat cover.
STEP 4: Once the front latch is clear of
the front latch plate you can slide the
cover forward to toe in the front tongue.
Gently check that the front tongue is
secure and lock the rear latch with the
key.
PRACTICE MAKES PERFECT
PART 2
The rst few times might
feel very confusing, but
practice these steps enough
times so it becomes second
nature and you will be able
to keep your cover in perfect
condition. Also take extra
care during Step 2 to avoid
hitting the seat.
P RO-TI P
To Next Page
Loading...
Need help?
General
