Optima OPF-P Series User Manual

OPF-P Series
User Manual / Getting Started
5/13
Contents
•
Scale main unit
•
Scale pan
•
User Manual
•
AC adapter
Alarms
•
Overload
•
When the load on the platform is over the maximum capacity
•
Take the load off immediately!
•
Unit weight
•
“LackofUnitWeight”: Average unit weight is not sufficient for accurate counting
•
Re-calibrate the sample weight using more samples.
•
Lack of number of sample
•
If the total weight of sample is below limit value
•
Low battery
•
When appears on the display, you're requested to recharge the scale over12 hours. When
the scale is recharging, the recharging symbol will flash.
•
Charging light
•
When the battery is charging, the charging light appears in red. When full, green.
•
Check quantity
•
When the check quantity function is on and the quantity is over the upper limit, a short
sound beeps. If the quantity is less than the lower limit, a long sound beeps.
Display/Keys
•
UNITS : In weighing mode, units can be changed between kg, g, lbs, and oz
•
QUANTITY CHECK : Sets up Upper and Lower limit
•
SAMPLE : Sets the counted sample number on the platform into scale memory
•
M+ : Accumulate counting (in counting mode); saves setting (in setting mode)
•
UNIT WEIGHT : Sets the unit weight data (in weighing mode); Exit key (in setting mode)
•
TOTAL : Used for recalling the count data, which is restored each time, and total accumulated
weight.
•
TARE : Tare (in weighing mode); Used to increase value (in setting mode)

Optima OPF-P Series Specifications

General

Brand	Optima
Model	OPF-P Series
Category	Scales
Language	English