OPF-P Series
User Manual / Getting Started
6/13
•
ZERO : Zero (in weighing mode); Used to decrease value (in setting mode)
•
CE : Cancel the set data (in weighing mode); Delete PLU value (in setting mode)
•
PLU : Used to enter PLU mode or setting PLU unit (in weighing mode); Exit key in PLU
mode
•
P0 to P21: PLU unit key; Used to store the unit weight in memory
Preparation
1. Carefully remove contents from the package which may include fragile parts.
2. Carefully assemble the scale by placing the scale pan.
3. Place the scale in a firm and flat surface, and avoid location where the scale
maybe subject to vibration, sunlight, airflow, contact with water, and strong
electromagnetic wave.
4. Level the scale by using the bubble level indicator (if available) and adjusting
the feet of the scale.
5. Locate scale in the following condition:
1. Temperature : 0
o
C ~ 40
o
C
6. Plug in the scale to a surge protected power outlet if using the AC adapter. If
using rechargeable batteries, fully charge the rechargeable batteries before use.
7. Turn the scale on and wait for it to finish initialization (i.e. when the display
shows a weight of 0).
8. Let the scale warm up for 1 minute before use.
9. Make sure any weight placed on the scale is not beyond the rated maximum.
10. If scale is not used for an extended period of time, disconnect all power.
To Next Page
Loading...
General