13
Battery Indicator
Power low
Suspend (hibernation) function is enabled:
- The beeper sounds at the same time.
- The computer automatically enters the hibernation
mode approximately 4 minutes after the beeper
sounds.
Suspend (hibernation) function is disabled:
- The beeper sounds approximately 7 minutes later.
- The computer automatically turns off several min-
utes after the beeper sounds.
Please continue normal use
Please continue normal use
Green
Orange
Charging
Fully charged
Action
Battery Status
Battery Indicator
"Power management" conserves battery power and enables the computer to be oper-
ated to the maximum extent possible. To run this program, select Wset25 in Win-
dows or Setup25 in DOS.
The computer enters the standby mode immediately after
+
Standby
are pressed.
In this mode, the HDD motor, CPU* and LCD backlight are turned off.
*Only when Windows is running.
Connect the AC adapter to the computer.
Replace the main battery with a fully charged
one.
If recharging is not possible at this time, imme-
diately save any open files on your disk and turn
off the power.
When the indicator remains red for a long time,
proceed with refreshing unless there has been a
sudden change in temperature.
The battery or AC adapter may not have been
connected properly.
Please wait until refreshing finishes. Press ESC
if you wish to abort.
Blinking green
Blinking orange
Refer to the Operating Instructions, and make
the proper connections. If the problem persists,
contact the Panasonic Service Center. (Trouble
may have occurred in the battery, charging con-
troller, etc.)
Blinking orange
for 5 seconds after
the AC adapter is
connected.
Refreshing required
Refreshing
The temperature is outside the range of approximately
5°C to 35°C (41°F to 95°F).
Please wait until the temperature falls within the
allowable range.
It is recommended that the battery is installed when using the computer.
In the setup program, set "Power Saving" in "Power Management" to "Advanced".
NOTE
Certain applications may not run when "Power Saving" is set to "Advanced". If this is the
case, set “Power Saving” to “Standard”.
When Windows is activated, click the "Start" button, move the cursor to "Settings", and click
"Control Panel". Select "Power" from the "Control Panel" to confirm that the "Advanced"
setting has been selected under "Power Management". The default setting is "Advanced".
Conserving Battery Power
Battery Power
Red
Refresh the battery pack. ( P.17)
Blinking red
To Next Page
Loading...
Need help?
General