Programming through the Web User Interface
41
Document Version 2010-08
Programming through the
Web user interface
You can program the following features through
the Web user interface. The password is required.
Contact your administrator for further information.
– Network settings
– Call forward (page 30, 37)
– Do not disturb (page 31, 38)
– Block anonymous calls (page 31, 38)
– Incoming call barring
*1
(page 31, 38)
– Anonymous calls (Block Caller ID) (page 32, 39)
– Updating the base unit software
*2
(page 33, 39)
*1 This feature is explained as “Call Rejection
Phone Numbers” in the Web user interface.
*2 This feature is explained as “Firmware Update”
in the Web user interface.
Embedded Web
You need to activate the Web user interface every
time you program features using a computer. The
Web user interface is deactivated after setting on
the computer.
The default setting is “Off”.
1 {MENU} (centre of joystick) i
{#}{5}{3}{4}
2 {V}/{^}: Select the desired setting.
3 {SAVE} i {OFF}
1 {MENU} (middle soft key) i {#}{5}{3}{4}
2 {V}/{^}: Select the desired setting.
3 {SAVE} i {EXIT}
Y Handset
: Base unit
To Next Page
Loading...
Need help?
General