18
6 Service Mode
6.1. Error Code Memory Function
1. General description
This unit is equipped with history of error code memory function, and can be memorized 16 error codes in sequence from the
latest. When the error is occurred more than 16, the oldest error is overwritten in sequence.
The error code is not memorized when the power supply is shut down forcibly (i.e.,when the unit is powered on by the battery,
the battery is pulled out) The error code is memorized to Flash-ROM when the unit has just before powered off.
2. How to display
The error code can be displayed by ordering the following procedure:
• Preparation
Attach the fully charged Battery, and insert the memory card (32MB or more).
Remove the lens cap.
• Step 1. The Temporary Cancellation of “Initial Settings”:
While pressing “[ RIGHT ] of Cursor button”, [ AF/AE LOCK ] button and [ DISP. ] button simultaneously, turn the power on.
• Step 2. Execute the Error Code Display Mode:
While pressing [ MENU/SET ] button, “[ LEFT ] of Cursor button” and [ AF/AE LOCK ] button simultaneously.
*The display is changed as shown below when the above buttons are pressed simultaneously.
Normal display → Error code display → Camera information display → Normal display → .....
[ Display method from the menu display ]
Select [ ERR CODE DISP ] from the setup menu and then press [ MENU/SET ] button with the step 1 condition.
*The display is changed as shown below when [ MENU/SET ] button is pressed.
Menu display → Error code display → Camera information display → Menu display → .....
Example of Error Code Display
To Next Page
Loading...
Need help?
General
