Application (Record)
Using the [Rec] menu
- 140 - VQT4J11
• For the setting procedures of the menu. (→25)
[Multi Expo.]
You can combine two or three still pictures into a single picture.
■
Settings
[Start] Start taking pictures.
Decide on your composition and take the first picture
Press to select [Next] and then press [MENU/SET]
• [Retake]: Delete the result of the last shot and take another picture.
• [Exit]: Exit Multi Exposure and save the picture that was taken.
Take the second and third pictures
• When you press [MENU/SET] while taking pictures, the pictures that
you took are saved and Multi Exposure is closed.
Use cursor button to select [Exit] and press [MENU/SET]
[Auto Gain] [ON]: Combines several pictures into one by automatically adjusting the
brightness in accordance with the number of pictures taken.
[OFF]: Combines several pictures into one by simply overlapping the
exposure results of all pictures, as is.
Since this setting may create a combined picture that is too bright
for some subject brightness level, perform Exposure Compensation
if required.
●
Still pictures are not saved in memory until Multi Exposure is ended.
●
Information for the picture taken last will be used as recording information of pictures
taken using Multi Exposure.
●
The picture size setting will be fixed at the point at which you select [Start].
●
The zoom position and White Balance are fixed at the point at which you take the first
picture.
●
There are some restrictions on the functions, for example, you will not be able to use
the following functions.
• [Burst Shooting]
• [i.Dynamic]
• [Auto Bracket]
• [Aspect Bracket]
• [WB Bracket]
To Next Page
Loading...
Need help?
General
